Quantum Scalar i2000 Guide de l'utilisateur Page 43

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 544
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 42
Chapter 2 Description
Tape Drives
Scalar i6000 User’s Guide 30
The control module and expansion modules have upper and lower drive
clusters. Each library must have at least one tape drive. Each drive cluster
can house up to six tape drives for a total of 12 drives. Additional drives
can be added to the first seven expansion modules in the configuration.
This enables you to have a total of 96 drives.
When you add drives, you lose storage slots.
Drives must be installed in bottom-to-top order in the control module
before any are added to the first expansion module. There are two six-
drive clusters in each of the first eight modules.
The term drive cluster defines a grouping of up to
six tape drives below or above the middle X-axis
rail.
Figure 8 on page 26 shows the locations of drives in the control module.
For details about the use of drives and cartridges, see
Mixed Media
Support and Rules on page 33.
Fibre Channel LTO-1, LTO-2, LTO-3, LTO-4,
LTO-5, DLT-S4, and SDLT-
600 drives can be connected to drive-aggregating Fibre Channel I/O
blades or directly attached to a host, so these drives do not require an
external SNC. More detailed information about LTO and SDLT drives
follows.
CAUTION
Although the physical library can contain more
than one media domain or drive domain, you
cannot have a mix of domain types within a
partition (for example, LTO and DLT).
A single partition can have a mixture of drive
types and interface types within the same
domain (for example, LTO-1 and LTO-2 with
SCSI or Fibre Channel interfaces).
Vue de la page 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 543 544

Commentaires sur ces manuels

Pas de commentaire