Quantum Scalar 24 Spécifications télécharger pdf (Page 29)

Scalar 24 Installation and Operation Guide 21

2 Connect the free end of the SCSI cable to the connector on the host computer’s SCSI adapter.

3 If you wish to connect one or more additional devices to the bus after the Scalar 24, connect an

appropriate cable between the remaining SCSI connector on the rear panel of the Scalar 24 and the

next device.

4 Terminate the last device in the chain.

5 Make sure that the SCSI cable between the host adapter and the Scalar 24 is secure and the

connections are fastened correctly.

Connecting More than One Scalar 24

If you are connecting more than one Scalar 24 on the same SCSI channel, connect each unit to the previous

unit with an additional shielded interface cable. It does not matter which SCSI connector on each Scalar 24

you connect the interface cable to. Make sure that you configure each Scalar 24 unit with a unique drive

SCSI ID and library ID. Your Scalar 24s will not function properly if they have the same SCSI IDs. For more

information on setting SCSI IDs, see Set SCSI IDs

on page 80.

CAUTION

Ensure that you are using the proper terminator for your type of SCSI

device.

Note

Ensure the cable is a 68-pin HD cable and is at least 2 feet (61 cm) in length.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 153 154

Pas de commentaire

Quantum Scalar 24 Spécifications Page 29