Quantum Scalar 24 Spécifications télécharger pdf (Page 57)

Scalar 24 Installation and Operation Guide 49

• Quality Testing

Compliance with these specifications can be checked and documented with the Ergilaser 3000 High Density

barcode measuring device that is manufactured by the Laetus Company.

Applying the Label

All barcode scanning labels should be applied to the front of the cartridge in the upper right corner of the

tape cartridge recess (when oriented vertically). Depending on the media type, barcode labels are either

stickers that are adhered to the front of the tape cartridge or cutouts that you slide into an indentation on the

front of the cartridge. To aid in readability, apply the labels so that the numbers are at the top of the label.

To install the barcode labels

1 Peel off the label and place it on the cartridge.

2 Verify that the label is oriented so that the numbers appear rightside up and above the barcode.

The following figure shows label application on LTO media.

Menu Navigation

Use tabbing and scrolling to navigate between menus and within a particular menu item. Tabbing and

scrolling are described in more detail below.

CAUTION

Be careful not to apply barcode labels upside down.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 153 154

Pas de commentaire

Quantum Scalar 24 Spécifications Page 57